- Washer and dryer hookup
Washer and dryer hookup
When it comes to washer and dryer hookup, there are a few simple steps to follow. First, youll need to determine what type of hookup is available in the space where the washer and dryer will be located. The two most common types of hookups are those that use a standard 120-volt electrical outlet and those that use a 240-volt outlet. Once youve identified which type of hookup is available, the next step is to purchase the appropriate hardware for the job. Depending on the type of hookup, you may need an adapter kit or a washer/dryer cord.
Once all the necessary hardware has been acquired, the next step is to make sure the power supply to the washer and dryer is turned off. This can be done by either turning off the circuit breaker or unplugging the unit from the electrical outlet, depending on which type of hookup you have. Once the power is off, its time to begin the installation. If youre installing a 120-volt hookup, then youll need to attach the adapter kit or cord to the back of the washer and dryer, then plug them into the wall outlet. If youre installing a 240-volt hookup, youll need to attach the appropriate wiring directly to the terminals on the washer and dryer.
Finally, once the washer and dryer are hooked up, its important to test that both the washer and dryer are functioning properly. This can be done by running a cycle with a small load of clothing and ensuring that there are no problems with either machine. If all goes well, then youre ready to start washing and drying your clothes!